Yaskawa Σ-V Series AC Servo Drives Rotational Motor Analog Voltage Reference - Manual (Page 56)

3.3 I/O Signal Allocations
3-21
3
Wi
ring and
C
onne
ctio
n
∗ If the Key has not been pressed but the Key has been pressed to select another mode such as the utility func-
tion mode, any changes that have been made to the parameter will be saved in the SERVOPACK.
(4) Checking Output Signals
Output signal status can be checked using the output signal monitor (Un006). As for the output signal monitor
(Un006), refer to 8.4 Monitoring Output Signals.
10
Refer to steps 5 to 9 and change the set value of Pn50F from n.0000 to n.0200.
Note: If setting Pn50F.2 to 2, /BK is allocated to CN1-9.
11 To enable the change in the setting, restart the SERVOPACK.
Step Display after Operation Keys Operation