Magnum Energy ME-RTR Router - Manual (Page 50)

©
2014 Magnum Energy, Inc. Page 42
Setup
Press to edit
setting if
available
Press
TECH
Rotate to
desired
selection:
Top line shows menu
Bottom line shows port
and menu item
01A INV BTS Temp
1 82F 2 ---- 3 ----
4 ---- 5 ---- 6 ----
ALL Read TECH
... ...
01A INV BTS Temp
1 -82F 2 ---- 3 ----
4 ---- 5 ---- 6 ----
ALL Read TECH 04 Fault History
Press SELECT
ALL View TECH
08 Load All Defaults
Press & hold SELECT
knob to Load in 5.0
ALL View TECH
Figure 3-17, TECH Button
TECH: 01 INV Temperatures
The TECH button’s fi rst menu displays temps of ALL the units connected to the router. The units
display in the order of the port# to which they are connected (1-6). Temperatures displayed are:
• 01A INV BTS Temp – Displays the temperature of each inverter’s Battery Temp Sensor (BTS)
that is connected to the battery bank.
• 01B INV Tfmer Temp – Displays the temperature of each inverter’s main power transformer.
• 01C INV FETs Temp – Displays the temperature of each inverter’s Field Effect Transistors (FET).
Info: The temperatures are displayed in Celsius or Fahrenheit, as selected in the SETUP
menu’s 01D Temp Display setting.
Note: You can view all three of the above temperature readings on a single port-specifi c display
for each connected inverter (see example below).
SETUP: 06 RC Setup
A remote control can be connected to the router and used to monitor your system. Refer to Section
9.0 “Attaching a Remote Control” for information on the available remote control menus using
the router.
Info: For additional information on the ME-RC or ME-ARC remote controls, refer to your
remote’s owner’s manual (PN: 64-0003 for a ME-RC; PN: 64-0030 for a ME-ARC) .
3.3.5 TECH Button and Menus
The TECH menu button provides access to selections that assist service technicians in troubleshooting.
It provides access to system information along with an option that allows all system settings to
be returned to the original factory default values. See Figure 3-17 below.
01 INV Temperatures
BTS ---F Tfmer ---F
FETs ---F
P1 Read TECH
To access the TECH button’s port-specifi c menus:
1. From the System Home screen (press and hold METER button for approx. 3 secs to access),
press the PORT button.
2. Continue to press the PORT button until the port# with the connected inverter appears (“INV
Home” displays in the lower right corner of screen).
3. Press the TECH button. The 01 INV Temperatures screen displays for the selected inverter.
Info: The remaining TECH menus can also be accessed as port-specifi c. However, these
menus are identical in function as when accessed as ALL ports TECH menus.
Figure 3-18, Port-Specifi c TECH Menus