HEIDENHAIN TNC 407 (243 020) Service Manual - Manual (Page 94)

D-83292
Kundendienst
SERVICE MANUAL TNC
Issue:
01.09.1995
Page 78
16.5.3 Offset Adjustment at the Servo-Amplifier
Check/adjust the following machine parameters. (Note down the original values before changing.)
Entry Function Original Value
1080.0 0
1080.1 0
1080.2 0
1080.3
1220
0
0
Integral factor
Cycle time for automatic offset
adjustment
1390 0 Feed ON precontrol
in the automatic operating modes
1510.0
1510.1
1510.2
1510.3
KV factor for feed precontrol
0 Display step = 1 pm
Switch position display to LAG (display of servo lag) (see sec. 16.3).
Clear the offset memory with the code number 75368 (see sec. 16.5.1).
Adjust the offset at the servo-amplifier until the values of the individual axes are zero
or oscillate symmetrically about zero.
Reset the machine parameter values and the position display to their original values.