HEIDENHAIN TNC 407 (243 020) Service Manual - Manual (Page 7)

SERVICE MANUAL TNC 15
Issue:
01.09.1995
Paae 4
2. Minor Error Messages
The TNC features a comprehensive integrated monitoring system to avoid input or operation errors, to
locate errors and technical defects of the entire equipment measuring system, machine tool, cables etc.).
The monitoring system is a fixed component of the TNC hardware and software; it is always
active
when the
control is switched on. If a technical defect or an operation error is detected, an error message in plain language
is on the screen.
To erase minor error messages, press
Further error messages are described in the
-Operating Manual TNC
-Technical Manual
Documentation by the machine tool manufacturer
Operating Instructions FE 401 B.
E R R O R M E S S A G E Section E R R O R M E S S A G E Section
AXIS DOUBLE
INCORRECT
POINT INACCESSIBLE
EXCEEDED
BAUD RATE NOT POSSIBLE
OPERATION PARAMETERS ERASED
CYCL-PARAMETER INCORRECT
TY RANGE DATA
MISSING
F A U L
DATA MED
DATA
I Y 14.5
DATA MEDIUM WRITE-PROTECTED 14.5
ROTATION NOT PERMITTED 13.2
PLANE WRONGLY DEFINED 13.2
LIMIT SWITCH 2.1
13.2
13.2
13.2
13.2
14.5
2.1
13.2
13.2
ERR: 001 14.5
ERR: 002 14.5
004 14.5
ERR: 010 14.5
ERR: 012 14.5
ERR: 013 14.5
ERR: 0 1 4 14.5
ERR: 100 14.5
ERR: 103 14.5
ERR: 104 14.5
ERR: 105 14.5
ERR: 106 14.5
ERR: 107 14.5
ERR: 108
EMERGENCY STOP
EXT. IN-/OUTPUT NOT READY
WRONG OPERATING MODE
WRONG PROGRAM DATA
SCALING FACTOR NOT PERMITTED
ME: TAPE END
HANDWHE
DEFECTIVE
HANDWHEEL
PLC
NOT TRANSLATED
PROGRAM
EXCHANGE BUF
INTERFACE
MIRRORING NO
RELAY
POWER IN
14.5
17.3
14.5
14.5
14.5
13.2
14.5
12.3
12.3
2.1
ERROR 2.1
INCOMPLETE 14.5
FERBATTERY 8.7
ALREADY ASSIGNED 14.5
PERMITTED 13.2
DC VOLTAGE MISSING 17.3
TERRUPTED 2.1
EXCHANGE TOUCH PROBE BATTERY 13.2
STYLUS ALREADY IN CONTACT 13.2
PROBE SYSTEM NOT READY 13.2
TIME LIMIT EXCEEDED 13.2