HEIDENHAIN TNC 407 (243 020) Service Manual - Manual (Page 72)

31-o SERVICE MANUAL TNC
01.09.1995
61
14.5.3 Error Messages at the FE in the ME-Mode
In
the ME-mode, errors are displayed by blinking indicator lamps
0 LED off LED blinking
Indicator Lamp Error Massage
Disk missing error in the ME electronics
Disk cannot be formatted, as it is currently being used
Disk missing or not formatted
Disk cannot be copied, as a read/write process is active
l O*@
0 0 0 0
External unit not ready or not connected
0 0 0 0
Disk missing or not formatted
Disk missing or not formatted or no program available
0 0 0 0
Program cannot be output, as a transfer is active via the TNC interface
0 0 . 0
Program cannot be output, as a transfer is active via the PRT interface
l ooo
External unit not ready or not formatted
Disk missing or not formatted
Disk missing or not formatted
Program cannot be output, as a transfer is active via the TNC interface
Program cannot be output, as a transfer is active via the PRT interface
External unit not ready or not connected
Disk missing or error in the ME electronics
Table of contents cannot be output, as a transfer is active via the PRT interface
No interface coupling possible, as a transfer is active via the TNC interface
0 0 0 0
No interface coupling possible, as a transfer is active via the PRT interface
0 0 0 0
External unit not ready or not connected
By pressing the error messages can be cleared.