HEIDENHAIN TNC 407 (243 020) Service Manual - Manual (Page 64)

31-O
Kundendienst
SERVICE MANUAL TNC
01.09.1995
Page 53.1
RANGE EXCEEDED
The range has been exceeded during scanning, a part of the is outside
the range.
CYCL-PARAMETER INCORRECT
The programmed travel or the distance between lines or points is negative or larger
than 56 535 mm (only possible via Q-parameter programming)
TOUCH POINT INACCESSIBLE
The stylus was deflected before the range was reached during approach.
In the cycle CONTOUR LINES, the stylus was not deflected within the probing range.
STYLUS ALREADY IN CONTACT
The stylus is not at rest, although it is not touching the contour,
PLANE WRONGLY DEFINED
One of the coordinates of the starting point in the cycle CONTOUR LINES is identical
with the touch probe axis.
START POSITION INCORRECT
The starting point coordinate that is identical to the starting probe axis, is beyond the range
AXIS DOUBLE PROGRAMMED
The same axis has been programmed for both starting point coordinates in the cycle
CONTOUR LINES.
TIME LIMIT EXCEEDED
In the scanning cycle CONTOUR LINES the first point of the scanned line was not reached
within the programmed time limit.