HEIDENHAIN TNC 407 (243 020) Service Manual User Manual
Page 84
SERVICE MANUAL TNC
Issue:
01.09.1995
Page 70.1
In the interface modes FEZ,
and EXT2 the name of the ASCII file must be entered manually,
as it cannot be displayed by the TNC.
** The file
always contains the tool table that is read by the TNC.
cannot be edited,
read out or downloaded. In the TNC several files
may be stored. The tool table
the
TNC is supposed to read must be copied into
I.e. after downloading the files
the
current tool table still needs to be copied into
Copying the file
into
Switch TNC to operating mode EDITING
(key on
Display of file names
Soft key
ALL< to display all file types
Press arrow key at the VDU to switch the soft-key
row to the file type display
Soft key
to display the tool tables
Press arrow key to switch back the soft-key row
If necessary: select file
with arrow key
Soft key
ABC
Enter file name TOOL, acknowledge with ENT
Soft key
to switch the TNC to the operating
mode EDITING