Err: 001, Err: 002, Err: 010 – HEIDENHAIN TNC 407 (243 020) Service Manual User Manual
Page 73: Err: 012, Err: 013, Err: 0 1 4, Err: 100, Err: 103, Err: 104, Err: 105
SERVICE MANUAL TNC
01.09.1995
Paae 62
14.5.4 Error Messages at the TNC in the FE-Mode
In this operating mode, the floppy disk unit outputs errors in the following format:
ERR:
XXX error number
The following errors can be displayed on the screen:
Input/output errors:
ERR: 001 wrong command code
ERR: 002 = illegal program name
ERR: 003 faulty data transfer
ERR: 004 program incomplete
ERR: 005 receiving buffer overflow
ERR: 006 function currently disabled
ERR: 007 data-buffer overflow
Errors during program write or read:
ERR: 010 program not on disk
ERR: 011 program erase-protected
ERR: 012 program is being written to
ERR: 013 program directory is full
ERR: 014 disk is full
ERR: 015 text not found
ERR: 016 program name already exists
ERR: 017 disk access active
ERR: 018 program currently being read
Disk Drive Controller Errors:
ERR: 100 disk not initialized
ERR: 101 sector number too large
ERR:
102
drive not ready
ERR: 103 disk is write-protected
ERR: 104 faulty data on disk
ERR: 105 sector cannot be found
ERR: 106 check sum incorrect
ERR: 107 disk controller defective
ERR: 108 DMA defective
ERR: 109 disk exchanged during program loading
These error messages indicate that the disk is defective; in most cases, they can only be
eliminated by formatting the disk anew.
If this error message comes up while the disk is inserted, the drive is defective.
Hardware error