HEIDENHAIN TNC 407 (243 020) Service Manual - Manual (Page 6)

HEIDENHAIN
D-83292
SERVICE MANUAL TNC
Kundendienst
01.09.1995
Page 3
How to use this Service Manual
The service manual TNC can be used to diagnose, locate and eliminate errors on machine tools
controlled by TNC.
In order to correctly judge the problems in an NC-controlled machine tool, fundamental knowledge of the
machine tool and its drives, as
as their interaction with the control and the measuring systems is
required. Incorrect of the machine tool can also result from improper use of the control,
programming errors and incorrect or not properly optimized machine parameter.
For further information in this respect please refer to the
of the Machine Tool Manufacturer
Manual (HEIDENHAIN)
Manual (HEIDENHAIN).
The manual for the machine tool manufacturer is not enclosed with every control as is the operating
manual. In general, it is only supplied to the machine tool manufacturer and is updated by HEIDENHAIN,
Traunreut. Therefore, it is absolutely necessary to contact the machine tool manufacturer, if errors occur
that are due to a machine parameter or to the interface of the control. Support will, however, also be
provided by the service department of HEIDENHAIN, Traunreut. and HEIDENHAIN agencies. Telephone
numbers, addresses and telex/fax numbers can be found on the back side of the cover page and on the
back side of this service manual.