Grass Valley PLS200 - Manual (Page 93)

Inserting the Packing Foam in the Library
PLS200 Library Installation and Operation 71
Inserting the Packing Foam in the Library
Be sure the packing foam assembly is disassembled before you begin.
1. Put the vertical piece of the foam assembly into the library next to the CHM,
as shown in Figure 6-1. Bend it as needed to get it through the door.
2. Maneuver the bottom cross piece (the one with the off-center notch) into
position and fit its notch to the notch in the vertical piece (arrow 1 in
Figure 6-1). Then bend the top of the vertical piece enough to attach the top
cross piece (arrow 2 in Figure 6-1).
3. Adjust the CHM on the long axis so that it will fit into the opening in the
vertical piece.
Figure 6-1 Installing the packing foam in the library
➊
➋