Grass Valley PLS200 - Manual (Page 153)

PLS200 Installation and Operation 131
Appendix
C
Bar Code Label Specification
This appendix provides specifications for creating bar code labels used on
cartridges in the PLS200 Library. These specifications include:
• Materials for the label
• Dimensions of the label
• Bar code characters
• Quality
• Optional features
Materials for the Label
Use the materials listed below to construct the bar code labels.
* After 24 hours on an actual data cartridge, the adhesive should exhibit a minimum
peel strength of 48 oz. per inch (536 gm/cm) of width using a peel rate of 10
inches/minute (25.4 cm/minute).
Base
Material White polyester film.
Laminate: A 0.001-inch (0.025-mm) thick, matte-finish polyester film,
which is secured with the same adhesive on the back.
Adhesive: *
(on the
back)
High tack.
Acrylic based.
Pressure sensitive.
Double sided.
Release
liner: 90-lb release liner stock.