Grass Valley PLS200 - Manual (Page 145)

PLS200 Library Installation and Operation 123
Appendix
B
LCD Error Codes
This appendix describes the error codes that appear on the library's LCD (liquid
crystal display). The error codes are listed in numerical order. LCD error codes
do not reflect tape drive errors.
CAUTION: Library components should be replaced only by qualified service
personnel. If you cannot find an obstruction or other obvious cause for the
error, contact your service provider.
CAUTION: Resetting the library will interrupt operation of the attached
Profile video disk recorder. If you must reset the library, shut down the VDR
first.
The columns in the table indicate the following:
• Error. The error code's number, which appears on the library's operator
panel LCD when the error occurs.
• Description. The error message that appears on the LCD, followed by a more
complete description of the error.
• Corrective Action. The recommended corrective action or actions.
!
!
Error Description Corrective Action
10 DROPPED A CARTRIDGE. The
CHM dropped a cartridge. If the cartridge label was removed, make sure that there is
no label adhesive remaining on the cartridge. If the label
was not removed, contact your service provider.
CAUTION: Do not try to put the cartridge back in the
gripper.
11 SOURCE EMPTY. There is no
cartridge in the source location. Request a new inventory of the cartridges in the library.
12 DESTINATION FULL. A cartridge
already exists in the destination
location. Request a new inventory of the cartridges in the library.