Grass Valley PLS200 - Manual (Page 148)

Appendix B LCD Error Codes
126 PLS200 Library Installation and Operation
40 L AXIS DOES NOT MOVE. The
CHM could not move along the long
axis. Open the door and look for anything that might be
obstructing the CHM along its long axis.
Make sure the library and tape drives are not being used by
any host, then press
on the operator panel. If the
error persists, contact your service provider.
41 L AXIS FAILED HOME. The CHM
could not return to the home position
on the long axis.
46 L LM629 RESET FAIL. The library
could not reset the servo chip for the
long axis. Make sure the library and tape drives are not being used by
any host, then press
on the operator panel. If the
error persists, contact your service provider.
50 D AXIS DOES NOT MOVE. The
drum could not move on its axis. Open the door and look for any obstructions around the
drum. If there are no obstructions, contact your service
provider.
51 D AXIS FAILED HOME. The library
could not determine the home position
for the drum. Contact your service provider.
60 NO LABEL. The bar code scanner
could not read the bar code label
because there was no label on the
cartridge. If present, this error appears on the Label Info screen. If
the cartridge does not have a label, place a label on the
cartridge. If the cartridge does have a label, reposition or
replace it. If the error persists, contact your service
provider.
61 READ ERROR. The bar code scanner
could not read the bar code label
because the label was unreadable.
62 NOT PRESENT. The bar code
scanner could not read the bar code
labels because there was no data
cartridge magazine present. If present, this error appears on the Label Info screen. If
necessary, install a data cartridge magazine.
65 DMA OVERRUN. The bar code
scanner could not read the bar code
label because a Direct Memory
Access overrun occurred. If present, this error appears on the Label Info screen.
Make sure the library and tape drives are not being used by
any host, then press
on the operator panel.
If the error persists, contact your service provider.
67 DMA CH. 2 TIMEOUT. Controller
board error.
Error Description Corrective Action
Reset
Reset
Reset