Grass Valley PLS200 - Manual (Page 149)

PLS200 Library Installation and Operation 127
69 LABEL UPSIDE DOWN. The bar
code scanner could not read the bar
code label because the label is upside
down. If present, this error appears on the Label Info screen.
Remove the label and reposition it on the cartridge. If the
label is affixed correctly, contact your service provider.
70 L SERVO TIMEOUT. The CHM
could not reach its destination along
the long axis. Open the door and look for anything that might be
obstructing the CHM along its long axis.
Make sure the library and tape drives are not being used by
any host, then press
on the operator panel. If the
error persists, contact your service provider.
71 PARAMETER > LIMIT. Firmware
error. Make sure the library and tape drives are not being used by
any host, then press
on the operator panel.
If the error persists, contact your service provider. You
may be asked to supply a diagnostic listing, and you may
need new firmware.
72 FRONT DOOR OPEN. The front
door is open or the door solenoid is
malfunctioning. • Close and lock the door.
• If the error still appears, make sure the library and tape
drives are not being used by any host, then press
on the operator panel.
• If the error persists, contact your service provider.
73 S SERVO TIMEOUT. The CHM
could not reach its destination along
the short axis. Open the door and look for anything that might be
obstructing the CHM along its short axis.
Make sure the library and tape drives are not being used by
any host, then press
on the operator panel. If the
error persists, contact your service provider.
75 INTERNAL S/W ERROR. Firmware
error. Make sure the library and tape drives are not being used by
any host, then press
on the operator panel.
If the error persists, contact your service provider. You
may be asked to supply a Diagnostic listing, and you may
need new firmware.
76 POS ERROR TIMEOUT. The CHM
could not reach its destination along
the long axis. Open the door and look for anything that might be
obstructing the CHM along its long axis.
Make sure the library and tape drives are not being used by
any host, then press
on the operator panel. If the
error persists, contact your service provider.
Error Description Corrective Action
Reset
Reset
Reset
Reset
Reset
Reset