Grass Valley PLS200 - Manual (Page 150)

Appendix B LCD Error Codes
128 PLS200 Library Installation and Operation
77 INTERFACE DISABLED. The
library was not in the correct control
mode when the operator sent a
command. Make certain the library is in the correct control mode. If
it is, contact your service provider.
80 E/E FAILED TO EXTEND. The
entry/exit port could not be extended. Open the door and look for obstructions around the
entry/exit transport arm. If there are no obstructions,
contact your service provider.
81 E/E FAILED TO RETURN. The
entry/exit port could not be retracted.
90 INVALID BLANK CONFIG. The
drive blank configuration is invalid. This error applies to earlier models of the library only. If
you operate the library with fewer than four drives, you
must have drive blanks installed in the empty slots. Tape
drives must be installed in contiguous slots, starting with
the top slot.
91 OPERATOR ABORTED. A
diagnostic was aborted while it was in
progress. No corrective action required.
97 DRIVE NOT INSTALLED. The tape
drive could not be cleaned because no
tape drive is installed in this location. This error only appears on the Clean Drives Menu. If no
tape drive is installed in the location, redirect the CHM. If
a tape drive is installed, make sure that the drive carrier is
correctly seated. If the error persists, contact your service
provider.
98 NO MAGAZINE. There is no
magazine installed in this location. If no magazine is installed in that location, redirect the
CHM. If a magazine is installed, make sure that it is
correctly seated on the mounting plate. If the error persists,
contact your service provider.
101 DRUM MOVE, S AXIS EXT. The
CHM could not move along the short
axis. Open the door and look for anything that might be
obstructing the CHM along its short axis.
Make sure the library and tape drives are not being used by
any host, then press
on the operator panel. If the
error persists, contact your service provider.
104 DRIVE DID NOT EJECT. The CHM
timed out waiting for a tape drive to
eject a cartridge. There may be a problem with the tape drive. Contact your
service provider.
Error Description Corrective Action
Reset