Grass Valley PLS200 - Manual (Page 85)

Replacing the Fuse
PLS200 Library Installation and Operation 63
Replacing the Fuse
The library uses a T4A (4.0-amp), 250-volt fuse, which is located in the fuse
drawer at the back of the library next to the power cord connector. An extra fuse
is provided in the fuse drawer. Replacement fuses are available generally from
electronic parts suppliers.
CAUTION: When replacing the fuse, use only the same type and rating of
fuse.
WARNING: Before performing any installation or maintenance procedures,
be sure that the library power switch is in the off position and that the power
cord is disconnected from the library and the outlet.
To replace the fuse:
1. Set the power switch to the off ( O ) position, and remove the power cord.
2. Place a small screwdriver underneath the tab on the fuse drawer. Lift out the
fuse drawer.
Figure 5-2 Replacing the fuse
3. Pull the blown fuse out of the fuse slot.
!
!
9619-1
1
2
3