Grass Valley PLS200 - Manual (Page 77)

Fields on Drive Status Screen
PLS200 Library Installation and Operation 55
Fields on Drive Status Screen
Drive Status:
DRIVE N
STATUS Identifies the tape drive, as follows:
DRIVE 1 – The top tape drive
DRIVE 2 – The second from top tape drive
DRIVE 3 – The third from top tape drive
DRIVE 4 – The bottom tape drive
Type Identifies the tape drive model. This information is updated at power-up and after a reset.
Note: “8mm” for Type indicates one of the following conditions:
• No tape drive is present in this slot.
• A Mammoth tape drive is installed, but the Use Mammoth configuration option is set
to OFF. (See page 41.)
• A tape drive firmware error has occurred.
Present Indicates whether a tape drive is installed in this slot:
0 – A tape drive is not present.
1 – A tape drive is present.
Accessible Indicates the accessibility of the tape drive to the CHM:
0 – A cartridge is loaded in the tape drive or the tape drive's status is unknown.
1 – A cartridge is protruding from the tape drive or the drive is empty.
Clean 0 – The tape drive is clean.
1 – The tape drive needs to be cleaned or the cleaning tape is used up.
Warning Not currently used.
Occupied 0 – There is no cartridge loaded in the tape drive.
1 – There is currently a cartridge loaded in the tape drive.
Occupied Valid 0 – The door has been opened or some other interruption has occurred so the occupied
information may not be reliable.
1 – The occupied information is reliable.