Grass Valley PLS200 - Manual (Page 50)

Chapter 1 Installing the Hardware
28 PLS200 Library Installation and Operation
Connect the Power Cord
➤ Important Tektronix ships the PLS200 with four power cords, each for use
in a different location. If none of the power cords are appropriate for your
location, you must supply a power cord with the proper plug that meets the
specifications listed in Appendix A, Specifications.
1. Make sure that the power switch on the back of the library is off (the 0 is
pressed ).
2. Connect the female end of the power cord to the power connector on the back
of the library.
3. Plug the male end of the power cord into the power source.
NOTE: The library has autoranging voltage selection, so you do not need to change
the voltage setting.
Power-on the Library
1. Make certain the library's door is closed and latched.
2. Push the power switch on the back of the library to the on ( I ) position.
3. Turn on the PDX103 or PRS200 if one of them is attached to the SCSI bus.
4. Turn on the Profile video disk recorder.
NOTE: When you turn on the VDR, a warning will appear that slot 2 needs to be
configured. This is normal and is addressed when you complete the SCSI
adapter board software update at the end of this chapter.
5. Wait while the library performs its power-on self-test. During this time, the
following activities occur:
- The cooling fan begins to rotate.
- The LCD illuminates and displays the Main Screen.
- The tape drives perform their power-on self-tests.
- The library performs its power-on self-test.