Grass Valley PLS200 - Manual (Page 31)

Install the Library Into a Rack
PLS200 Library Installation and Operation 9
Installing the Slide Rails
1. Identify the holes on the rack where you want to install the library. The
library will extend 1 to 2 inches (3 to 4 cm) below the slide rails.
2. If the rack does not have threaded holes, attach the eight clip nuts over the
holes (see Figure 1-4).
3. Using a T-25 TORX driver and eight 10-32
×
0.5 screws, attach, but do not
tighten, the slide rails to the rack (see Figure 1-4).
Figure 1-4 Attaching the slide rails