Grass Valley PLS200 - Manual (Page 57)

Setting the SCSI IDs
PLS200 Library Installation and Operation 35
3. Press to move the up and down screen arrows to D3, as shown. Press
or until the screen displays the SCSI ID you want.
NOTE: If any drive carrier slot contains a drive blank, the cursor will skip over the
SCSI ID field for that slot.
4. Continue this process until you have set the SCSI IDs for all tape drives and
the library.
5. When the SCSI IDs for all tape drives and the library are correct, press
to accept your choices. If you have changed one or more of the tape
drive IDs, the library displays the following screen:
6. Press . The library resets the tape drives that have changed IDs and
redisplays the Configuration Menu.
S C S I D 4 D 3 D 2 D 1 L I B
I D s : 0 2 0 1 0 2 0 1 0 5
↑
← ↓ →
Enter
P r e s s E N T E R t o r e s e t
t h e d r i v e ( s ) o r E S C
t o c a n c e l t h e S C S I
I D c h a n g e s .
Enter