Grass Valley PLS200 - Manual (Page 35)

Install the Library Into a Rack
PLS200 Library Installation and Operation 13
7. If the holes in the rack are not threaded, install a clip nut on each side of the
rack, as shown in Figure 1-8.
Figure 1-8 Securing the library in the rack
8. Slide the library completely into the rack. Use a T-25 TORX driver to insert
the two 10-32
×
1.0 pan head screws on the front panel, as shown in
Figure 1-8. These screws prevent the library from sliding out of the rack.
9. Replace the air filter grilles on each side of the front panel.