Deleting groups in batches, Managing meters, Viewing the meter list – H3C Technologies H3C Intelligent Management Center User Manual
Page 70: See "viewing the meter list
60
Deleting groups in batches
1.
In the group list, select one or more groups.
2.
Click Delete.
The confirmation dialog box appears.
3.
Click OK.
Managing meters
Meters enable OpenFlow to implement various simple QoS operations, such as rate-limiting. A meter
table consists of meter entries. An OpenFlow switch can have only one meter table.
shows the
components of a meter entry.
Figure 25 Meter entry components
For more information about the meter entry components, referenced in
, see version 1.3.1 of the
Open Networking Foundation "OpenFlow Switch Specification" located at:
Each meter includes one or more bands. Only a single band is used at a time. Each band specifies the
rate at which the band applies and the way packets should be processed. If the current rate of packets
exceeds the rate of multiple bands, the band with the highest configured rate is used.
The meter management module of SDNM is used to view, query, add, modify, and delete meters, which
helps create traffic control rules.
NOTE:
One or more of the links above goes outside the Hewlett-Packard website. HP does not control and is not
responsible for information outside of the HP website.
Viewing the meter list
1.
Click the Service tab.
2.
From the navigation tree, select VAN SDN Manager > Flow Management > OF Meter.
The meter management page appears.
Meter list contents
{
Meter ID—Integer uniquely identifying the group.
{
DPID—DPID of the OpenFlow instance to which the meter belongs. A DPID uniquely identifies
an OpenFlow instance. Click a DPID to view the OpenFlow instance details. For more
information, see "
Managing an OpenFlow instance on the OpenFlow instance details page