H3C Technologies H3C Intelligent Management Center - Manual (Page 49)

39
Viewing the SDN information
The SDN Info tab displays the following parameters for an OpenFlow switch:
• OF Instance List
{
DPID—DPID of the OpenFlow switch.
{
Controller—Controller to which the OpenFlow switch is connected.
{
Member VLAN—VLAN on which the OpenFlow switch takes effect.
{
OF Entry—Number of flow entries in the OpenFlow switch.
• Interface List
{
Interface Status—Status of the physical or logical interface on the OpenFlow switch: Up, Down,
or Disabled.
{
Interface Description—Description of the interface on the OpenFlow switch, such as
Ten-GigabitEthernet2/0/1 or Vlan-interface2.
{
MAC Address—MAC address of the OpenFlow interface.
{
DPID—DPIDs of OpenFlow instances that use this interface. Click the Details icon to view
the list of OpenFlow instances.
{
Device Status—Active condition of the interface: In Use or Unused.
{
OpenFlow—Whether or not the OpenFlow forwarding is enabled for the interface.
• Endpoint list
{
IP Address—IP address of the endpoint.
{
MAC Address—MAC address of the endpoint.
{
Port Index—Index of the port to which the endpoint is connected.
{
Discovery Time—Time when the OpenFlow instance discovered the endpoint.
Managing controller configurations for an OpenFlow switch
Only HP ProCurve devices support controller configuration management. This function enables you to
manage IP addresses, ports, and device interfaces for controllers. A controller is uniquely identified by
an ID for connections.
Viewing the controller configuration list
To view the controller configuration list of an OpenFlow switch:
1. Click the Service tab.
2. From the navigation tree, select VAN SDN Manager > OF Resource > OF Devices.
3. On the page that appears, click the OF Switch tab.
4. Click the Operation icon for a switch and select Controller Setting.
The controller configuration list includes all controller configurations on the OpenFlow switch.
{
Controller configuration list contentsID—ID of the controller. OpenFlow instances use the ID to
communicate with the controller.
{
IP Address—IP address of the controller. Click the link to view detailed information about the
controller.