H3C Technologies H3C Intelligent Management Center - Manual (Page 50)

40
{
Controller Interface—VLAN port or OOBM port through which the OpenFlow instance is
connected to the controller.
{
Port—Listening port of the controller, with a fixed value of 6633.
{
OF Instances—Number of OpenFlow instances managed by the controller.
{
Modify—Click the Modify icon to modify configurations of the controller. The icon does not
appear if the controller is connected to OpenFlow instances.
{
Delete—Click the Delete icon to delete configurations of the controller. The icon does not
appear if the controller is connected to OpenFlow instances.
Querying controller configurations
1. In the query box on the top right corner of the controller list area, enter a partial or a complete IP
address of the controller.
2. Click the Query icon .
The controller list displays controllers that match the criterion.
Adding the configuration of a controller
Add configurations of new controllers to an OpenFlow switch after they are added to SDNM. The new
configurations cannot be the same as any existing configurations on the switch. The maximum number of
supported controllers on an HP ProCurve device varies with the device model. When the maximum
number is reached, no additional configurations can be added to the device.
To add a controller configuration to an OpenFlow switch:
1. On the Controller Setting page, click Add.
2. On the page that appears, configure the following parameters:
{
IP Address—Select an IP address for the controller from the list.
{
Port—Configure the listening port of the controller with a fixed value of 6633.
{
Management VLAN—Enter the ID of the VLAN in which OpenFlow instances are connected to
the controller.
{
Use OOBM Port—Configure a port for out-of-band management on blade switches.
3. Click OK.
When a virtual OpenFlow device is added on the switch, SDNM automatically adds the controller
configurations on the switch to the virtual OpenFlow device. For more information about managing
virtual OpenFlow devices, see " Managing virtual OpenFlow devices ."
Modifying the configuration of a controller
This function is used to modify the management VLAN of a controller on an OpenFlow switch when the
controller is not connected to any OpenFlow instances.
To modify the configuration of a controller on an OpenFlow switch:
1. On the Controller Setting page, click the Modify icon for a controller.
2. Modify the management VLAN.
3. Click OK.