Meter table, Sdnm homepage – H3C Technologies H3C Intelligent Management Center User Manual
Page 14
4
•
Group ID—A unique identifier for a group.
•
Group Type—Type of the group:
{
All
{
Indirect
{
Select
{
Fast Failover
•
Counters—Counter for a group.
•
Action Buckets—An ordered action bucket list for a group. Each action bucket contains a set of
actions to be executed and associated parameters. Algorithms performed for an action bucket vary
with group types.
NOTE:
One or more of the links above take you outside the Hewlett-Packard website. HP does not control and is
not responsible for information outside of the HP website.
Meter table
Meters are used for OpenFlow to support Quality of Service (QoS). An OpenFlow instance has only one
meter table. A meter table has zero or more meter entries. Any flow entry can specify a meter in its
instructions set, and the meter measures and controls the rates of flows assigned to it.
A meter entry includes the following fields:
Figure 4 Meter entry
For more information about the meter entry referenced in
, see version 1.3.1 of the Open
Networking Foundation "OpenFlow Switch Specification" located at:
•
Meter ID—A unique identifier for a meter.
•
Meter Bands—An unordered meter band list. Each meter band specifies a flow rate and a
processing mode.
•
Counters—Counter for a meter.
NOTE:
One or more of the links above take you outside the Hewlett-Packard website. HP does not control and is
not responsible for information outside of the HP website.
SDNM homepage
shows the SDNM homepage.