beautypg.com

Configuring controller connection parameters – H3C Technologies H3C Intelligent Management Center User Manual

Page 21

background image

11

Figure 9 SDNM service flow

Configuring controller connection parameters

By using SDNM, you can configure global connection parameters for controllers. IMC uses the
configured connection parameters to connect to the controller and initiate an authentication when a

controller is added to IMC. If IMC passes the authentication, the controller is identified as a controller by

SDNM.
To configure controller connection parameters:

1.

Click the Service tab.

2.

From the navigation tree, select VAN SDN Manager > Configuration.
The configuration page appears.

3.

Configure the following controller connection parameters:

See also other documents in the category H3C Technologies Safety: