H3C Technologies H3C Intelligent Management Center - Manual (Page 53)

43
2. Execute the instruction set if the packet is matched:
{
Modify the packet and update its match fields by using the Apply-Actions instruction.
{
Update the action set by using the Clear-Actions and Write-Actions instructions.
{
Update metadata by using the Write-Metadata instruction.
{
Send the matched packet and action set to the next flow table by using the Goto-Table
instruction.
The flow entries in the last flow table do not contain the Goto-Table instruction.
3. Execute the action set of the packet when pipeline processing stops.
Figure 22 OpenFlow packet matching process
For more information about the OpenFlow packet matching process, referenced in Figure 22 , see version
1.3.1 of the Open Networking Foundation "OpenFlow Switch Specification" located at:
https://www.opennetworking.org/images/stories/downloads/sdn-resources/onf-specifications/open
flow/openflow-spec-v1.3.1.pdf
NOTE:
One or more of the links above take you outside the Hewlett-Packard website. HP does not control and is
not responsible for information outside of the HP website.
Viewing the flow table list
1. Click the Service tab.
2. From the navigation tree, select VAN SDN Manager > Flow Management > OF Table.
Flow table list contents
{
Table ID—ID of the flow table in its OpenFlow instance. A table ID uniquely identifies a flow
table in an OpenFlow instance (a logical OpenFlow switch).
{
OF Entry—Number of flow entries in the flow table. Click the number to view the flow entries on
the flow entry management page for the flow table. For more information about flow entries, see
" Managing flow entries ."