H3C Technologies H3C S7500E Series Switches - Manual (Page 417)

14-15
To do… Use the command… Remarks
Enter system view system-view —
Enter BGP view bgp as-number —
Enter IPv6 MBGP address
family view
ipv6-family multicast —
Configure the maximum number
of equal-cost routes for load
balancing
balance number
Required
By default, load balancing is
disabled.
Configuring a Large Scale IPv6 MBGP Network
Configuration Prerequisites
Before configuring the following tasks, you need to configure IPv6 MBGP basic functions.
Configuring an IPv6 MBGP Peer Group
For easy management and configuration, you can organize some IPv6 MBGP peers having the
same route update policy into a group, known as a peer group. A policy configured for a peer
group applies to all the members in the group.
Follow these steps to configure an IPv6 MBGP peer group:
To do… Use the command… Remarks
Enter system view system-view —
Enter BGP view bgp as-number —
Enter IPv6 address family view ipv6-family —
Create an IPv6 BGP peer group
group ipv6-group-name
[ external | internal ]
Required
Add a peer to the peer group
peer ipv6-address group
ipv6-group-name [ as-number
as-number ]
Required
By default, no peer is added.
Enter IPv6 MBGP address
family view
ipv6-family multicast —
Enable the configured IPv6
unicast BGP peer group to
create the IPv6 MBGP peer
group
peer ipv6-group-name enable Required