H3C Technologies H3C S7500E Series Switches - Manual (Page 250)

8-16
z To configure an MBGP peer group, you need to enable the corresponding IPv4 BGP unicast peer
group in IPv4 MBGP address family view.
z Before adding an MBGP peer to an MBGP peer group, you need to add the corresponding IPv4
unicast peer to the IPv4 BGP peer group.
Configuring MBGP Community
The community attribute can be advertised between MBGP peers in different ASs. Routers in the
same community share the same policy.
You can reference a route policy to modify the community attribute for routes sent to a peer. In addition,
you can define extended community attributes as needed.
Follow these steps to configure MBGP community:
To do… Use the command… Remarks
Enter system view system-view —
Enter BGP view bgp as-number —
Enter IPv4 MBGP address family view ipv4-family multicast —
Advertise the
community
attribute to an
MBGP
peer/peer
group
peer { group-name | ip-address }
advertise-community
Advertise the
community attribute
to an MBGP
peer/peer group
Advertise the
extended
community
attribute to an
MBGP
peer/peer
group
peer { group-name | ip-address }
advertise-ext-community
Required
Not configured by default.
Apply a route policy to routes
advertised to an MBGP peer/peer
group
peer { group-name | ip-address }
route-policy route-policy-name
export
Required
Not configured by default.