H3C Technologies H3C S7500E Series Switches - Manual (Page 283)

9-27
To do... Use the command... Remarks
Configure 802.1p precedence
for MLD Messages
mld-snooping dot1p-priority
priority-number
Required
The default 802.1p precedence
for MLD messages is 0.
Displaying and Maintaining MLD Snooping
To do… Use the command... Remarks
Display MLD snooping multicast
group information (on a distributed
device)
display mld-snooping group [ vlan
vlan-id ] [ slot slot-number ]
[ verbose ]
Available in any
view
Display information about MLD
Snooping multicast groups (on a
distributed IRF device)
display mld-snooping group [ vlan
vlan-id ] [ chassis chassis-number slot
slot-number ] [ verbose ]
Available in any
view
Display the statistics information of
MLD messages learned by MLD
snooping
display mld-snooping statistics
Available in any
view
Remove dynamic group entries of a
specified MLD snooping group or all
MLD snooping groups
reset mld-snooping group
{ ipv6-group-address | all } [ vlan
vlan-id ]
Available in user
view
Clear the statistics information of all
kinds of MLD messages learned by
MLD snooping
reset mld-snooping statistics
Available in user
view
z The reset mld-snooping group command works only on an MLD snooping–enabled VLAN,
but not on a VLAN with MLD enabled on its VLAN interface.
z The reset mld-snooping group command cannot remove the static group entries of MLD
snooping groups.