H3C Technologies H3C S7500E Series Switches - Manual (Page 102)

4-18
Network diagram
Figure 4-6 Network diagram for creating an RPF route
Switch A Switch B Switch C
Vlan-int102
30.1.1.2/24
Vlan-int101
20.1.1.2/24
Vlan-int101
20.1.1.1/24
Vlan-int102
30.1.1.1/24
Source 1 Source 2 Receiver
40.1.1.100/24 10.1.1.100/24
Multicast static route
Vlan-int200
40.1.1.1/24
Vlan-int100
10.1.1.1/24
OSPF domain
PIM-DM
50.1.1.100/24
Vlan-int300
50.1.1.1/24
Configuration procedure
1) Configure IP addresses and unicast routing
Configure the IP address and subnet mask for each interface as per Figure 4-6. The detailed
configuration steps are omitted here.
Enable OSPF on Switch B and Switch C. Ensure the network-layer interoperation among
Switch B and Switch C. Ensure that the switches can dynamically update their routing
information by leveraging the unicast routing protocol. The specific configuration steps are
omitted here.
2) Enable IP multicast routing, and enable PIM-DM and IGMP
# Enable IP multicast routing on Switch C, enable PIM-DM on each interface, and enable IGMP
on the host-side interface VLAN-interface 100.
system-view
[SwitchC] multicast routing-enable
[SwitchC] interface vlan-interface 100
[SwitchC-Vlan-interface100] igmp enable
[SwitchC-Vlan-interface100] pim dm
[SwitchC-Vlan-interface100] quit
[SwitchC] interface vlan-interface 101
[SwitchC-Vlan-interface101] pim dm
[SwitchC-Vlan-interface101] quit
# Enable IP multicast routing on Switch A and enable PIM-DM on each interface.
system-view
[SwitchA] multicast routing-enable
[SwitchC] interface vlan-interface 300
[SwitchC-Vlan-interface300] pim dm
[SwitchC-Vlan-interface300] quit
[SwitchC] interface vlan-interface 102
[SwitchC-Vlan-interface102] pim dm
[SwitchC-Vlan-interface102] quit