H3C Technologies H3C S7500E Series Switches - Manual (Page 284)

9-28
MLD Snooping Configuration Examples
IPv6 Group Policy and Simulated Joining Configuration Example
Network requirements
z As shown in Figure 9-4 , Router A connects to the IPv6 multicast source through
GigabitEthernet 2/0/2 and to Switch A through GigabitEthernet 2/0/1. Router A is the MLD
querier on the subnet.
z MLDv1 is required on Router A, MLD snooping version 1 is required on Switch A, and
Router A will act as the MLD querier on the subnet.
z It is required that the receivers, Host A and Host B, attached to Switch A can receive IPv6
multicast traffic addressed to IPv6 multicast group FF1E::101 only.
z It is required that IPv6 multicast data for group FF1E::101 can be forwarded through
GigabitEthernet 2/0/3 and GigabitEthernet 2/0/4 of Switch A even if Host A and Host B
accidentally, temporarily stop receiving IPv6 multicast data.
Figure 9-4 Network diagram for IPv6 group policy simulated joining configuration
Source
Router A Switch A
Receiver
Receiver
Host B
Host A
Host C
GE2/0/1
GE2/0/4
GE2/0/2
GE2/0/3
MLD querier
1::1/64
GE2/0/1
2001::1/64 GE2/0/2
1::2/64
Configuration procedure
1) Enable IPv6 forwarding and configure IPv6 addresses
Enable IPv6 forwarding and configure an IPv6 address and prefix length for each interface as
per Figure 9-4 . The detailed configuration steps are omitted.
2) Configure Router A
# Enable IPv6 multicast routing, enable IPv6 PIM-DM on each interface, and enable MLDv1 on
GigabitEthernet 2/0/1.
system-view
[RouterA] multicast ipv6 routing-enable
[RouterA] interface gigabitethernet 2/0/1
[RouterA-GigabitEthernet2/0/1] mld enable
[RouterA-GigabitEthernet2/0/1] pim ipv6 dm
[RouterA-GigabitEthernet2/0/1] quit
[RouterA] interface gigabitethernet 2/0/2
[RouterA-GigabitEthernet2/0/2] pim ipv6 dm