H3C Technologies H3C S7500E Series Switches - Manual (Page 406)

14-4
To do… Use the command… Remarks
Enter IPv6 MBGP address
family view
ipv6-family multicast —
Specify a preferred value for
routes received from the IPv6
MBGP peer/peer group
peer { ipv6-group-name |
ipv6-address } preferred-value
value
Optional
The preferred value defaults to
0.
If you both reference a route policy and use the command peer { ipv6-group-name |
ipv6-address } preferred-value value to set a preferred value for routes from a peer/peer group,
the route policy sets a non-zero preferred value for routes matching it. Other routes not
matching the route policy uses the value set with the command. If the preferred value in the
route policy is zero, the routes matching it will also use the value set with the command. For
information about using a route policy to set a preferred value, refer to the peer
{ ipv6-group-name | ipv6-address } route-policy route-policy-name { import | export }
command and the apply preferred-value preferred-value command in Route Policy
Configuration Commands in the Layer 3 - IP Routing Command Reference.
Controlling Route Distribution and Reception
Configuration Prerequisites
Before configuring this task, you need to:
z Enable IPv6.
z Configure the IPv6 MBGP basic functions.
Injecting a Local IPv6 MBGP Route
Follow these steps to inject a local IPv6 MBGP route:
To do… Use the command… Remarks
Enter system view system-view —
Enter BGP view bgp as-number —
Enter IPv6 MBGP address
family view
ipv6-family multicast —
Inject a network to the IPv6
MBGP routing table
network ipv6-address
prefix-length [ route-policy
route-policy-name | short-cut ]
Required
Not injected by default