H3C Technologies H3C S7500E Series Switches - Manual (Page 369)

13-18
For the configuration of other timers in IPv6 PIM-DM, refer to Configuring IPv6 PIM Common
Timers .
Configuring IPv6 PIM-SM
IPv6 PIM-SM Configuration Task List
Complete these tasks to configure IPv6 PIM-SM:
Task Remarks
Enabling IPv6 PIM-SM Required
Configuring a static RP Optional
Configuring a C-RP Optional
Enabling embedded RP Optional
Configuring an RP
Configuring C-RP timers globally Optional
Configuring a C-BSR Optional
Configuring an IPv6 PIM domain border Optional
Configuring C-BSR parameters globally Optional
Configuring a BSR
Configuring C-BSR timers Optional
Configuring IPv6 Multicast Source Registration Optional
Configuring SPT Switchover Optional
Configuring IPv6 PIM Common Features Optional
Configuration Prerequisites
Before configuring IPv6 PIM-SM, complete the following task:
z Configure any IPv6 unicast routing protocol so that all devices in the domain are
interoperable at the network layer.
Before configuring IPv6 PIM-SM, prepare the following data:
z The IP address of a static RP and an ACL rule defining the range of IPv6 multicast groups
to be served by the static RP
z C-RP priority and an ACL rule defining the range of IPv6 multicast groups to be served by
each C-RP