H3C Technologies H3C S7500E Series Switches - Manual (Page 387)

13-36
To do... Use the command... Remarks
Configure the join/prune interval
pim ipv6 timer join-prune
interval
Optional
60 seconds by default
Configure the join/prune timeout
time
pim ipv6 holdtime join-prune
interval
Optional
210 seconds by default
Configure assert timeout time
pim ipv6 holdtime assert
interval
Optional
180 seconds by default
If there are no special networking requirements, we recommend that you use the default
settings.
Configuring Join/Prune Message Sizes
A larger join/prune message size will result in loss of a larger amount of information when a
message is lost; with a reduced join/message size, the loss of a single message will bring
relatively minor impact.
By controlling the maximum number of (S, G) entries in a join/prune message, you can
effectively reduce the number of (S, G) entries sent per unit of time.
Follow these steps to configure join/prune message sizes:
To do... Use the command... Remarks
Enter system view system-view —
Enter IPv6 PIM view pim ipv6 —
Configure the maximum size of
a join/prune message
jp-pkt-size packet-size
Optional
8,100 bytes by default
Configure the maximum number
of (S, G) entries in a join/prune
message
jp-queue-size queue-size
Optional
1,020 by default