H3C Technologies H3C S7500E Series Switches - Manual (Page 416)

14-14
To do… Use the command… Remarks
Enter IPv6 address family view ipv6-family —
Enable BGP route refresh for a
peer/peer group
peer { group-name |
ipv6-address }
capability-advertise
route-refresh
Optional
Enabled by default
If this feature is not enabled,
you need to configure this
command.
Enable the non-standard ORF
capability for a BGP peer/peer
group
peer { group-name |
ipv6-address }
capability-advertise orf
non-standard
Optional
By default, standard BGP ORF
capability defined in RFC 5291
and RFC 5292 is supported.
If this feature is not enabled,
you need to configure this
command.
Enter IPv6 MBGP multicast
address family view
ipv6-family multicast —
Enable the ORF IP prefix
negotiation capability for a BGP
peer/peer group
peer { group-name |
ipv6-address }
capability-advertise orf
ip-prefix { both | receive |
send }
Required
Not supported by default
Table 14-1 Description of the both, send, and receive parameters and the negotiation result
Local parameter Peer parameter Negotiation result
receive
send
both
The ORF sending capability is enabled locally
and the ORF receiving capability is enabled on
the peer.
send
receive
both
The ORF receiving capability is enabled locally
and the ORF sending capability is enabled on
the peer.
both both
Both the ORF sending and receiving
capabilities are enabled locally and on the
peer, respectively.
Configuring the Maximum Number of Equal-Cost Routes for Load-Balancing
Follow these steps to configure the maximum number of equal-cost routes for load-balancing: