beautypg.com

Anycast rp configuration, Network requirements – H3C Technologies H3C S7500E Series Switches User Manual

Page 225

background image

7-24

5) Verify the configuration

Carry out the display bgp peer command to view the BGP peering relationships between the

switches. If the command gives no output information, a BGP peering relationship has not been

established between the switches.

When the multicast source in PIM-SM 1 (Source 1) and the multicast source in PIM-SM 2 (Source 2)

send multicast information, receivers in PIM-SM 1 and PIM-SM 3 can receive the multicast data. You

can use the display msdp brief command to view the brief information of MSDP peering relationships

between the switches. For example:

# View the brief MSDP peer information on Switch B.

[SwitchB] display msdp brief

MSDP Peer Brief Information

Configured Up Listen Connect Shutdown Down

2 2 0 0 0 0

Peer's Address State Up/Down time AS SA Count Reset Count

192.168.3.2 Up 01:07:08 ? 8 0

192.168.1.2 Up 00:16:39 ? 13 0

# View the brief MSDP peer information on Switch C.

[SwitchC] display msdp brief

MSDP Peer Brief Information

Configured Up Listen Connect Shutdown Down

1 1 0 0 0 0

Peer's Address State Up/Down time AS SA Count Reset Count

192.168.1.1 Up 01:07:09 ? 8 0

# View the brief MSDP peer information on Switch E.

[SwitchE] display msdp brief

MSDP Peer Brief Information

Configured Up Listen Connect Shutdown Down

1 1 0 0 0 0

Peer's Address State Up/Down time AS SA Count Reset Count

192.168.3.1 Up 00:16:40 ? 13 0

Anycast RP Configuration

Network requirements

z

The PIM-SM domain has multiple multicast sources and receivers. OSPF runs within the domain

to provide unicast routes.

z

It is required to configure the anycast RP application so that the receiver-side DRs and the

source-side DRs can initiate a Join message to their respective RPs that are the topologically

nearest to them.

z

On Switch B and Switch D, configure the interface Loopback 10 as a C-BSR, and Loopback 20 as

a C-RP.

z

The router ID of Switch B is 1.1.1.1, while the router ID of Switch D is 2.2.2.2. Set up an MSDP

peering relationship between Switch B and Switch D.