beautypg.com

Configuration procedure – H3C Technologies H3C S7500E Series Switches User Manual

Page 131

background image

5-24

Configuration procedure

1) Configure IP addresses and unicast routing

Configure the IP address and subnet mask of each interface as per

Figure 5-5

. The detailed

configuration steps are omitted here.

Configure the OSPF protocol for interoperation on the PIM network. Ensure the network-layer

interoperation on the PIM network and dynamic update of routing information among the

switches through a unicast routing protocol. The detailed configuration steps are omitted here.

2) Enable IP multicast routing, and enable PIM-DM and IGMP

# Enable IP multicast routing on Switch A, enable PIM-DM on each interface, and enable IGMP

on VLAN-interface 100.

system-view

[SwitchA] multicast routing-enable

[SwitchA] interface vlan-interface 100

[SwitchA-Vlan-interface100] igmp enable

[SwitchA-Vlan-interface100] pim dm

[SwitchA-Vlan-interface100] quit

[SwitchA] interface vlan-interface 101

[SwitchA-Vlan-interface101] pim dm

[SwitchA-Vlan-interface101] quit

# Enable IP multicast routing on Switch B, enable PIM-DM on each interface, and enable IGMP

on VLAN-interface 200.

system-view

[SwitchB] multicast routing-enable

[SwitchB] interface vlan-interface 200

[SwitchB-Vlan-interface200] igmp enable

[SwitchB-Vlan-interface200] pim dm

[SwitchB-Vlan-interface200] quit

[SwitchB] interface vlan-interface 201

[SwitchB-Vlan-interface201] pim dm

[SwitchB-Vlan-interface201] quit

# Enable IP multicast routing on Switch C, enable PIM-DM on each interface, and enable IGMP

on VLAN-interface 200.

system-view

[SwitchC] multicast routing-enable

[SwitchC] interface vlan-interface 200

[SwitchC-Vlan-interface200] igmp enable

[SwitchC-Vlan-interface200] pim dm

[SwitchC-Vlan-interface200] quit

[SwitchC] interface vlan-interface 202

[SwitchC-Vlan-interface202] pim dm

[SwitchC-Vlan-interface202] quit

3) Verify

the

configuration

Carry out the display igmp interface command to view the IGMP configuration and operation

status on each switch interface. For example:

# Display IGMP information on VLAN-interface 200 of Switch B.

[SwitchB] display igmp interface vlan-interface 200

Vlan-interface200(10.110.2.1):