H3C Technologies H3C S7500E Series Switches - Manual (Page 196)

6-59
Network diagram
Figure 6-13 Network diagram for PIM-SSM configuration
Ether
net
Ether
net
E
thernet
N1
N2
Vl
an-
in
t101
Vlan-
int10
1
Device Interface IP address Device Interface IP address
Switch A Vlan-int100 10.110.1.1/24 Switch D Vlan-int300 10.110.5.1/24
Vlan-int101 192.168.1.1/24 Vlan-int101 192.168.1.2/24
Vlan-int102 192.168.9.1/24 Vlan-int105 192.168.4.2/24
Switch B Vlan-int200 10.110.2.1/24 Switch E Vlan-int104 192.168.3.2/24
Vlan-int103 192.168.2.1/24 Vlan-int103 192.168.2.2/24
Switch C Vlan-int200 10.110.2.2/24 Vlan-int102 192.168.9.2/24
Vlan-int104 192.168.3.1/24 Vlan-int105 192.168.4.1/24
Configuration procedure
1) Configure IP addresses and unicast routing
Configure the IP address and subnet mask for each interface as per Figure 6-13 . Detailed
configuration steps are omitted here.
Configure the OSPF protocol for interoperation among the switches in the PIM-SM domain.
Ensure the network-layer interoperation in the PIM-SM domain and enable dynamic update of
routing information among the switches through a unicast routing protocol. Detailed
configuration steps are omitted here.
2) Enable IP multicast routing, and enable PIM-SM and IGMP
# Enable IP multicast routing on Switch A, enable PIM-SM on each interface, and run IGMPv3
on VLAN-interface 100, which connects Switch A to the stub network.
system-view
[SwitchA] multicast routing-enable
[SwitchA] interface vlan-interface 100
[SwitchA-Vlan-interface100] igmp enable
[SwitchA-Vlan-interface100] igmp version 3