H3C Technologies H3C S7500E Series Switches - Manual (Page 370)

13-19
z A legal C-RP address range and an ACL rule defining the range of IPv6 multicast groups to
be served
z C-RP-Adv interval
z C-RP timeout
z C-BSR priority
z Hash mask length
z An IPv6 ACL rule defining a legal BSR address range
z BS period
z BS timeout
z An IPv6 ACL rule for register message filtering
z Register suppression time
z Register probe time
z The IPv6 ACL rule, and sequencing rule for disabling an SPT switchover
Enabling IPv6 PIM-SM
With IPv6 PIM-SM enabled, a router sends hello messages periodically to discover IPv6 PIM
neighbors and processes messages from the IPv6 PIM neighbors. When deploying an IPv6
PIM-SM domain, you are recommended to enable IPv6 PIM-SM on all non-border interfaces of
the routers.
Follow these steps to enable IPv6 PIM-SM:
To do... Use the command... Remarks
Enter system view system-view —
Enable IPv6 multicast routing multicast ipv6 routing-enable
Required
Disable by default
Enter interface view
interface interface-type
interface-number
—
Enable IPv6 PIM-SM pim ipv6 sm
Required
Disabled by default
All the interfaces of the same device must work in the same IPv6 PIM mode.
For details about the multicast ipv6 routing-table command, see IPv6 Multicast Routing and
Forwarding Configuration Commands in the IP Multicast Command Reference.