H3C Technologies H3C S7500E Series Switches - Manual (Page 181)

6-44
PIM Configuration Examples
PIM-DM Configuration Example
Network requirements
z Receivers receive VOD information through multicast. The receiver groups of different
organizations form stub networks, and one or more receiver hosts exist in each stub
network. The entire PIM domain operates in the dense mode.
z Host A and Host C are multicast receivers in two stub networks.
z Switch D connects to the network that comprises the multicast source (Source) through
VLAN-interface 300.
z Switch A connects to stub network N1 through VLAN-interface 100, and to Switch D
through VLAN-interface 103.
z Switch B and Switch C connect to stub network N2 through their respective VLAN-interface
200, and to Switch D through VLAN-interface 101 and VLAN-interface 102 respectively.
z IGMPv2 is to run between Switch A and N1, and between Switch B/Switch C and N2.
Network diagram
Figure 6-10 Network diagram for PIM-DM configuration
Ether
net
Ether
net
Ethern
et
N1
N2
Vlan-
in
t10
2
Vlan-
int1
02
Vl
an-
int10
3 Vlan-
int
103
Device Interface IP address Device Interface IP address
Switch A Vlan-int100 10.110.1.1/24 Switch D Vlan-int300 10.110.5.1/24
Vlan-int103 192.168.1.1/24 Vlan-int103 192.168.1.2/24
Switch B Vlan-int200 10.110.2.1/24 Vlan-int101 192.168.2.2/24
Vlan-int101 192.168.2.1/24 Vlan-int102 192.168.3.2/24
Switch C Vlan-int200 10.110.2.2/24
Vlan-int102 192.168.3.1/24
Configuration procedure
1) Configure IP addresses and unicast routing