H3C Technologies H3C S7500E Series Switches - Manual (Page 317)

11-7
Follow these steps to configure the IPv6 multicast forwarding table size:
To do... Use the command... Remarks
Enter system view system-view —
Configure the maximum number
of entries in the IPv6 multicast
forwarding table
multicast ipv6
forwarding-table route-limit
limit
Optional
512 by default.
Configure the maximum number
of downstream nodes for a
single IPv6 multicast forwarding
entry
multicast ipv6
forwarding-table
downstream-limit limit
Optional
128 by default.
Configuring IPv6 Static Multicast MAC Address Entries
In Layer-2 multicast, a Layer-2 IPv6 multicast protocol (such as MLD snooping) can
dynamically add IPv6 multicast MAC address entries. Or, you can manually configure IPv6
multicast MAC address entries.
Configuring an IPv6 static multicast MAC address entry in system view
Table 11-1 Configure an IPv6 static multicast MAC address entry in system view
To do... Use the command... Remarks
Enter system view system-view —
Configure a static multicast
MAC address entry
mac-address multicast
mac-address interface
interface-list vlan vlan-id
Required
No static multicast MAC address
entries exist by default.
Configuring an IPv6 static multicast MAC address entry in interface view
Table 11-2 Configure an IPv6 static multicast MAC address entry in interface view
To do... Use the command... Remarks
Enter system view system-view —
Enter Ethernet interface/Layer 2
aggregate interface view or port
group view
interface interface-type
interface-number
Required
Configurations performed in
Ethernet interface view or Layer
2 aggregate interface view take
effect for only the current
interface; while that performed
in port group view take effect for
all ports in the port group.