Network diagram, Configuration procedure – H3C Technologies H3C S7500E Series Switches User Manual
Page 223
7-22
z
It is required that Switch C and Switch E be configured as static RPF peers of Switch B, and
Switch B be configured as the only static RPF peer of Switch C and Switch E, so that any switch
can receive SA messages only from its static RPF peer(s) and permitted by the corresponding
filtering policy.
Network diagram
Figure 7-6 Network diagram for inter-AS multicast configuration leveraging static RPF peers
Vlan-int101
Vlan-
int10
2
Switch B
Switch A
Source 1
AS 100
PIM-SM 1
PIM-SM 3
PIM-SM 2
Loop0
Switch C
Switch D
Switch E
Switch F
Source 2
Vlan-int100
Vlan-
in
t103
Vlan-int101
Vlan-int104
Vlan-int105
Loop0
Receiver
Receiver
Loop0
Static RPF peers
Vlan-
int1
03
Vlan-
in
t2
00
Vlan-int104
Vlan-int105
Vl
an-
int300
Vlan-
int40
0
AS 200
Vlan-
int1
02
Device Interface
IP
address
Device Interface
IP
address
Switch A
Vlan-int103
10.110.1.2/24
Switch D
Vlan-int104
10.110.4.2/24
Vlan-int100
10.110.2.1/24
Vlan-int300
10.110.5.1/24
Vlan-int200
10.110.3.1/24
Switch E
Vlan-int105
10.110.6.1/24
Switch B
Vlan-int103
10.110.1.1/24
Vlan-int102 192.168.3.2/24
Vlan-int101
192.168.1.1/24
Loop0
3.3.3.3/32
Vlan-int102
192.168.3.1/24
Switch F
Vlan-int105
10.110.6.2/24
Loop0
1.1.1.1/32
Vlan-int400 10.110.7.1/24
Switch C
Vlan-int101
192.168.1.2/24 Source
1 —
10.110.2.100/24
Vlan-int104
10.110.4.1/24
Source 2
—
10.110.5.100/24
Loop0
2.2.2.2/32
Configuration procedure
1) Configure IP addresses and unicast routing
Configure the IP address and subnet mask for each interface as per
Detailed configuration
steps are omitted here.
Configure OSPF for interconnection between the switches. Ensure the network-layer interoperation in
each AS, and ensure the dynamic update of routing information among the switches through a unicast
routing protocol. Detailed configuration steps are omitted here.
2) Enable IP multicast routing, enable PIM-SM and IGMP, and configure a PIM-SM domain border
# Enable IP multicast routing on Switch A, enable PIM-SM on each interface, and enable IGMP on the
host-side interface VLAN-interface 200.
[SwitchA] multicast routing-enable