Pim-sm non-scoped zone configuration example, Network requirements – H3C Technologies H3C S7500E Series Switches User Manual
Page 184
6-47
Downstream interface(s) information:
Total number of downstreams: 3
1: Vlan-interface103
Protocol: pim-dm, UpTime: 00:03:27, Expires: never
2: Vlan-interface101
Protocol: pim-dm, UpTime: 00:03:27, Expires: never
3: Vlan-interface102
Protocol: pim-dm, UpTime: 00:03:27, Expires: never
PIM-SM Non-Scoped Zone Configuration Example
Network requirements
z
Receivers receive VOD information through multicast. The receiver groups of different
organizations form stub networks, and one or more receiver hosts exist in each stub
network. The entire PIM-SM domain contains only one BSR.
z
Host A and Host C are multicast receivers in two stub networks.
z
Switch D connects to the network that comprises the multicast source (Source) through
VLAN-interface 300.
z
Switch A connects to stub network N1 through VLAN-interface 100, and to Switch D and
Switch E through VLAN-interface 101 and VLAN-interface 102 respectively.
z
Switch B and Switch C connect to stub network N2 through their respective VLAN-interface
200, and to Switch E through VLAN-interface 103 and VLAN-interface 104 respectively.
z
Vlan-interface 105 on Switch D and Vlan-interface 102 on Switch E act as C-BSRs and
C-RPs; the C-BSR on Switch E has a higher priority; the multicast group range served by
the C-RP is 225.1.1.0/24; modify the hash mask length to map a certain number of
consecutive group addresses within the range to the two C-RPs.
z
IGMPv2 is to run between Switch A and N1, and between Switch B/Switch C and N2.