H3C Technologies H3C S7500E Series Switches - Manual (Page 211)

7-10
Follow these steps to create an MSDP peer connection:
To do... Use the command... Remarks
Enter system view system-view —
Enter public instance MSDP view
or VPN instance MSDP view
msdp [ vpn-instance
vpn-instance-name ]
—
Create an MSDP peer connection
peer peer-address
connect-interface interface-type
interface-number
Required
No MSDP peer connection created
by default
If an interface of the router is shared by an MSDP peer and a BGP/MBGP peer at the same time, we
recommend that you use the IP address of the BGP/MBGP peer as the IP address of the for the
MSDP peer.
Configuring a Static RPF Peer
Configuring static RPF peers avoids RPF check of SA messages.
Follow these steps to configure a static RPF peer:
To do... Use the command... Remarks
Enter system view system-view —
Enter public instance MSDP view
or VPN instance MSDP view
msdp [ vpn-instance
vpn-instance-name ]
—
Configure a static RPF peer
static-rpf-peer peer-address
[ rp-policy ip-prefix-name ]
Required
No static RPF peer configured by
default
If only one MSDP peer is configured on a router, this MSDP will be registered as a static RPF peer.
Configuring an MSDP Peer Connection
Configuration Prerequisites
Before configuring MSDP peer connection, complete the following tasks: