H3C Technologies H3C S7500E Series Switches - Manual (Page 218)

7-17
z It is required that the respective Loopback 0 of Switch B, Switch C and Switch E be configured as
the C-BSR and C-RP of the respective PIM-SM domains.
z It is required that an MSDP peering relationship be set up between Switch B and Switch C
through EBGP, and between Switch C and Switch E through IBGP.
Network diagram
Figure 7-5 Network diagram for inter-AS multicast configuration leveraging BGP routes
Vl
an
-int103
Vl
an
-int103
Vl
an-
int20
0
Vlan-
int30
0
Vl
an-
int40
0
Device Interface IP address Device Interface IP address
Switch A Vlan-int103 10.110.1.2/24 Switch D Vlan-int104 10.110.4.2/24
Vlan-int100 10.110.2.1/24 Vlan-int300 10.110.5.1/24
Vlan-int200 10.110.3.1/24 Switch E Vlan-int105 10.110.6.1/24
Switch B Vlan-int103 10.110.1.1/24 Vlan-int102 192.168.3.2/24
Vlan-int101 192.168.1.1/24 Loop0 3.3.3.3/32
Loop0 1.1.1.1/32 Switch F Vlan-int105 10.110.6.2/24
Switch C Vlan-int104 10.110.4.1/24 Vlan-int400 10.110.7.1/24
Vlan-int102 192.168.3.1/24 Source 1 — 10.110.2.100/24
Vlan-int101 192.168.1.2/24 Source 2 — 10.110.5.100/24
Loop0 2.2.2.2/32
Configuration procedure
1) Configure IP addresses and unicast routing
Configure the IP address and subnet mask for each interface as per Figure 7-5 . Detailed configuration
steps are omitted here.
Configure OSPF for interconnection between switches in each AS. Ensure the network-layer
interoperation among each AS, and ensure the dynamic update of routing information between the
switches through a unicast routing protocol. Detailed configuration steps are omitted here.
2) Enable IP multicast routing, enable PIM-SM on each interface, and configure a PIM-SM domain
border
# Enable IP multicast routing on Switch A, enable PIM-SM on each interface, and enable IGMP on the
host-side interface VLAN-interface 200.
system-view