Teac HS-4000 - Manual (Page 68)

68
TASCAM HS-4000
8 – Take mode
In this chapter, we explain how to use the take mode.
To use this unit in take mode, set the unit’s operation mode to
TAKE MODE.(See “Selecting the operation mode” on page 49.)
Please refer to “4 – Basic operation” when reading this chapter.
Preparing to record
Basic preparations
Refer to “4 – Basic operation” on page 30 as you conduct basic
preparations.
Creating a new project
Create new projects as necessary. You do not need to create a
new project if you plan to record into an existing one.
1. Press the PROJECT key on the front panel to open the
PROJECT screen.
2. Touch the CREATE PROJECT button on the PROJECT screen
to open the CREATE PROJECT screen.
On the first page, you can set the project name, the name
of the first created session, the sampling frequency, and the
sampling frequency written to BWF chunks.
Touch the NEXT button to open the next page.
Next, set the frame type and bit length.
Touch the NEXT button to open the next page.
Finally, set the starting time and number of tracks to be
recorded in timeline mode, and then set whether other
settings should be retained from the currently open project
or whether the factory defaults should be used instead.
For details, see “Creating new projects” on page 39.
3. After you complete making settings touch the CREATE
PROJECT button.
NOTE
If a project with the same project name already exists, the
CREATE PROJECT button appears gray and you will not be
able to create a new project. If this happens, change the
project name.
4. When the confirmation message appears in a pop-up, press
the OK button.
When creation of the project completes, the Home Screen
reopens.
Creating new sessions
Create new sessions as necessary. You do not need to create a
new session if you plan to record into an existing one.
1. Press the PROJECT key on the front panel to open the
PROJECT screen.
2. Touch the e button of the project to which you want to add
a session to open the session selection screen.
If it is not the current project, a pop-up window appears
confirming that you want to load it.
3. Touch the OK button. Touch the MAKE SESSION button to
open the MAKE SESSION screen.
4. Touch the Session Name button to open the SESSION NAME
screen where you can change the session name.
Use the same input method as in “Editing the project name”
on page 40.
NOTE
You cannot use the “@” symbol at the beginning of a session
name.