Teac HS-4000 - Manual (Page 114)

114
TASCAM HS-4000
11 – Internal settings
preset data affect operation, use the Load Preset item User
button to load it.
0 If there is no system backup file, a pop-up window appears
stating the importing will not occur.
Save User Preset
Touch the Save button to save the current settings as preset
data in the built-in memory.
Load Preset
Touch the User button to load the user preset settings or the
Factory button to load the factory preset settings (values set
when unit shipped).
Startup MODE
Last Setting: Last used settings are restored at startup.
User Preset: User Preset settings are used at startup.
Factory Preset: Factory Preset settings are used at startup.
NOTE
• The following backup settings, which are not saved with
projects, are included when saving and loading a preset.
Screen name Page name Setting
Home Screen
Time counter display
mode
LOCK SETUP
screen
All settings
PLAY SETUP
screen
CONTROL page PLAY Inhibit Time
SYNC T/C screen
CLOCK page MASTER
SYNC page Master TC
ON AIR Fs screen ON AIR Fs
REMOTE SETUP
screen
GENERAL page
FADER MODE
FADER Start MODE
FADER Stop MODE
PARALLEL page AUX Assign
RS-232C page All settings
ETHERNET page All settings
MIXER SETUP
screen
INPUT page
INPUT SOURCE
MONITOR PAN
MONITOR MIXER
page
PreFader/PostFader
SETUP page
Output 1-4 MonoMix
Output 1-4 Source
SYSTEM SETUP
screen
PREFERENCE
page
All settings
REFERENCE LEVEL
page
All settings
ANA Ref LVL ADJ
page
All settings
Backup/Startup
page
Startup MODE
OPERATION
MODE
screen
Whether the
operation mode is on
air mode or another
mode. (If anything
other than on air
mode, the operation
mode saved on the
CF card is made
active.)
VERSION/OPTION
screen
WAV LOCK page WAV LOCK
• When the unit is shipped new, the user preset settings are
the same as the factory preset settings.
• When the user preset memory Startup MODE setting is
set to Last Setting or Factory Preset, if the Startup MODE
is changed to User Preset but the Save User Preset is not
executed, the User Preset will load the next time the unit
starts. Then, however, the Startup Mode saved in the User
Preset memory (Last Setting or Factory Preset) will be
restored. At this time, the Last Setting or Factory Preset
settings will not be reloaded. The next time the unit is
started, though, the Last Setting or Factory Preset settings
will be loaded.
CLOCK ADJUST page
Set the time of the built-in clock.
Touch the item that you want to set, and use the DATA dial to
adjust the item.(See “Setting the time of the built-in clock” on
page 27.)
Touch the SET button on the CLOCK ADJUST page or press the
DATA dial to confirm the setting.
NOTE
While setting the time, the clock stops and the “:” does not
blink.
When you touch the SET button, the clock starts again and
the “:” blinks.