Teac HS-4000 - Manual (Page 103)

TASCAM HS-4000
103
11 – Internal settings
• After an Audio Over or Sync Unlock automatic mark is
added, the same type of mark will not be added again until
at least 10 seconds pass.
Playback settings (PLAY SETUP)
Make playback settings.
GENERAL page (PLAY SETUP screen)
Make various settings related to the playback mode on this
page.
Play Mode
Set how the playback of takes and entries is handled using
the following buttons. This setting affects all modes except
timeline mode.
• One Take (default)
Only the currently selected take or playback is played
back.
• All Take
All the takes in the currently loaded session or all the
entries in the playlist are played back.
NOTE
• In timeline mode, the Play Mode setting is fixed to "All Take"
and cannot be changed.
• In A/B MIXED mode, the Play Mode setting is fixed to "One
Take" and cannot be changed.
Repeat Mode
Turn repeat playback ON and OFF (default).
Follow BWF-J
Turn the BWF-J cue point function ON or OFF (default).
This setting can be made separately for each mode.
When the BWF-J cue point function is ON, operation will
follow BWF-J cue points set in sessions and takes.
For details about operation, see the following pages.
Timeline mode: “BWF-J cue points (timeline mode)” on
page 54
Take mode: “BWF-J cue points (take mode)” on page
72
Playlist mode: “BWF-J cue points (playlist mode)” on
page 97
On-air mode: “BWF-J cue point (on-air mode)” on page
100
BC$END Mode
You can set the following functions that are different from
ordinary BC$END operations during on air playback.
• Normal (default)
An END cue signal is output and playback continues.
• Jump to Standby
An END cue signal is output and the transport jumps to
the BC$STANDBY mark of the next take and playback
continues. If the next take does not have a BC$STANDBY
mark, playback will continue without jumping.
NOTE
This setting is only effective when in on air mode. It is not
shown in other operation modes.
CONTROL page
Make various settings related to the playback functions on this
page.
NOTE
In A/B MIXED mode, the Auto Cue, Auto Ready and Inc. Play
settings are fixed to OFF and cannot be changed.
Auto Cue
Turn the auto cue function ON or OFF (default).
If auto cue is ON, whenever a take is changed or loaded, the
unit will enter playback standby at the point where sound
first starts in the take.
When Play Mode is set to One Take and no sound is detected
before the end of the take, the unit stops at the start of
the take. When Play Mode is set to All Take and no sound
is detected before the end of the take, the unit continues
detection in the next take.
This setting affects all modes except timeline mode.
To set the auto cue start point detection level, touch the
knob area and use the DATA dial to change the value.
–72dB, –66dB, –60dB, –54dB (default), –48dB, –42dB, –36dB,
–30dB, –24dB
Auto Ready
Turn the auto ready function ON or OFF (default).
If auto ready is ON, when playback of the current take
completes the unit will enter playback standby at the
beginning of the next take.