Teac HS-4000 - Manual (Page 54)

54
TASCAM HS-4000
7 – Timeline mode
BWF-J cue points (timeline mode)
When the Follow BWF-J item on the GENERAL page of the PLAY
SETUP screen is ON, if a BWF-J cue point is detected during
playback, the following operations will occur. In addition, when
the BWF-J tally item on the PARALLEL page of the REMOTE
SETUP screen is ON, cue signals and tally signals will be output
from the parallel remote connector in response to each BWF-J
cue point. However, when playback is synchronized with
timecode, only the CUE signal and tally signal will be output.
BC$STANDBY
When a session is loaded, the transport
moves to the first BC$STANDBY point,
and playback standby starts. During
playback, when this point is reached,
playback standby starts. In either case, a
BC$STANDBY tally is output.
BC$CM
During playback, when this point is
reached, a BC$CM cue signal is output.
BC$END
During playback, when this point is
reached, a BC$END CUE signal is output.
BC$STOP
During playback, when this point is
reached, a BC$STOP CUE signal is output,
and playback stops.
BC$FILE
During playback, when this point is
reached, a BC$END CUE signal is output.
BC$PAUSE
During playback, when this point is
reached, a BC$PAUSE tally is output, and
playback standby starts.
Importing and exporting AES31
editing information
Importing AES31 editing information
You can import AES31 editing information located in the current
session to the currently loaded session.
When viewed on a computer, the folder of the CF card should be
as follows.
{CF drive name}:\{project name}\{session name}\{AES31
editing information}
NOTE
You cannot import an AES31 editing information file from a
folder other than that of the current session.
1. Press the PROJECT key on the front panel to open the
PROJECT screen.
2. Touch the e button next to the project that contains the
session with the AES31 editing information that you want to
import to open the session selection screen.
If it is not the current project, a pop-up window appears
confirming that you want to load it. Touch the OK button.
3. Touch the e button for the session with the AES31 editing
information that you want to import to open the AES31
selection screen.
If it is not the current project, a pop-up window appears
confirming that you want to load it. Touch the OK button.
If AES31 editing files are found in the session, they appear in
the list.
TIP
If you press the INFO button after selecting a file by touching
the filename area, the date and time last changed and the
file size of that file are shown.
4. Press the e button for the AES31 editing information file
that you want to import.
After the project loads, the Home Screen reopens.